Aus der Trad-Tech Anleitung bestätigt sich das, was man mir bereits zu WM gesagt hatte:
Draw Weight:
Your TradTech Bow or riser comes with the draw weight set at the base minimum weight unless you’ve instructed
us to customize it especially for you. This factory weight setting can always be duplicated by first loosening
and taking the In-Line Limb Bolt Locking Set Screws out of the riser; then turn the limb bolts lightly snug
against the bronze bushings and loosen exactly 5 turns counterclockwise to find the minimum setting, then
replace and retighten the In-Line Limb Locking Set Screws securely.
**NOTE: DO NOT ADJUST THE LIMB BOLTS BEYOND THIS MINIMUM SETTING TO PREVENT RISER/
LIMB DAMAGE AND POSSIBLE INJURY!
To increase your bow’s draw weight; Use the 5/32” Hex Wrench to loosen each In-Line Limb Bolt Locking Set
Screw counter-clockwise by the number of turns you wish to increase the draw weight plus ½ turn. Then using
the 3/16” Hex Wrench, tighten each Limb Bolt up to three(3) turns from the factory minimum base weight and
re-tighten the In-Line Limb Bolt Locking Set Screws.
** The factory maximum weight setting can always be duplicated by removing the In-Line Limb Bolt Locking
Set Screws and tightening the Limb Bolts lightly snug against the bronze limb bushings and then turning the
Limb Bolts counterclockwise two(2) turns, then replacing and re-tightening the Locking Set Screws securely.
**Exceeding this maximum factory setting may result in difficulty removing/inserting your ILF limbs, increased
weight stacking at full draw/decreased smoothness and dramatically increased stress on your limbs leading to
potential early limb fatigue or failure.
Hab auch Bignami mal angemailt, mal sehen, ob die was schicken. Denn die "Pilze" brauchen 22 Umdrehungen zum abmachen, das Gewinde ist also lang. Wenn man es sagen wir: 10 Umdrehungen, also knapp die hälfte rausdreht, dann stehen die WAs so schräg, dass es rein visuell schon nicht passen kann. Drehe ich die aber nur die 4 Umdrehungen raus, so kann ich die Konter-Madenschraube nicht festziehen, weil die kein Gewinde erwischt.
Irgenwie bereue ich es schon, dass ich in dieser Saison IB schiessen will. Mein Compound hat mehr schrauben, ist aber einfacher einzustellen.
Likes